Common parts in Threaded Rod Grade 12.9 Steel mechanical equipment need to be cleaned and maintained regularly to ensure their normal operation and extend their service life. The following are the cleaning and maintenance methods for screws and guide rails:
1. High Tensile 12.9 Threaded Rod Remove dust and dirt:
Use a soft brush or clean cloth to wipe the surface of the screw to remove dust and dirt. For stains that are difficult to remove, you can use a neutral detergent to wet the cloth and wipe it.
2. Steel Grade 12.9 Threaded Rod Remove oil stains:
If there is oil on the surface of the screw or guide rail, you can use a special cleaning agent or detergent to clean it. First, dilute the cleaning agent and spray it on the screw and guide rail according to the instructions, then wipe it with a brush or cloth, and finally rinse it with clean water.
3.Class 12.9 Steel Threaded Rods Lubrication and maintenance:
After cleaning, the screw and guide rail need to be lubricated and maintained. According to the requirements and specifications of the equipment, select appropriate lubricating oil or grease and add it to the surface of the screw and guide rail. Be careful not to use excessive lubricants.
4. Galvanized Fully Threaded Rod Stud Bolt Rod Check wear and looseness:
Regularly check the wear of the screw and guide rail. If there is severe wear, it should be replaced in time. At the same time, check whether the fixing bolts of the screw and guide rail are loose. If they are loose, they should be tightened.
5. Threaded rod DIN 976 Keep dry at all times:
The screw and guide rails should be kept dry to prevent rust and corrosion. Avoid water or moisture from directly contacting the screw and guide rails, and check the humidity of the surrounding environment regularly.
Post time: Jul-17-2024