In some photovoltaic power generation systems, the flatness of the array is an important indicator. The flatness of the array has an important impact on the light utilization rate and power generation efficiency. Therefore, high installation accuracy is required. Different, flatness is difficult to guarantee. The existing support beams and columns are generally connected by 45 degree angle solar panel.
where is solar panel angle and direction use?
In some photovoltaic power generation systems, the flatness of the array is an important indicator. The flatness of the array has an important impact on the light utilization rate and power generation efficiency. Therefore, high installation accuracy is required. Different, flatness is difficult to guarantee. The existing support beams and columns are generally connected by corner brace.
Construction of corner brace
The metal angle brackets is composed of a base plate and two triangular wing plates. The base plate is connected to the photovoltaic support, and the triangular wing plate is connected to the column.
what it is attention after installation about fixdex angle solar panel?
After installation, the photovoltaic support and the column are relatively fixed. This installation method, even if the flatness of the array There are differences and it is difficult to adjust, so it can only be used according to the installed form.
Safe and reliable installation, maximum use effect with minimum installation cost, almost maintenance-free, reliable repair
The triangular connection device of the photovoltaic support includes a rectangular bottom plate and triangular wing plates symmetrical to both sides of the rectangular bottom edge. The triangular wing plate has a special-shaped wing plate, and a long waist hole is opened on the special-shaped wing plate; , the triangular wing plate is connected with the column of the photovoltaic support.
The triangular wing plate and the special-shaped wing plate are integrated, and the special-shaped wing plate is recessed inward.
A through hole is arranged on the column, and the bolt passes through the through hole on the column and the elongated waist hole to connect the upright column and the triangular wing plate, and the bolt can move along the elongated waist hole.
The two ends of the elongated waist hole are semicircular.
There are mounting holes on the bottom plate, through which the photovoltaic support is fixed.
Post time: Nov-19-2024