What is a welding-free photovoltaic bracket base?

The solar panel mounting bracket base includes a casing formed by bending a steel plate. The casing has a “U” shaped cross-section and has a rear side plate and a rear side connecting the rear side plate.

Read More: Catalog photovoltaic bracket

solar panel brackets base function

When using solar panel mounts with embedded bolt foundations on the ground or cement roof, they need to be connected with a base. When preparing a traditional base, the sleeve 10 and the base plate 20 need to be prepared separately first, and then the lower end of the sleeve 10 is welded to the middle position of the upper surface of the base plate 20 . Obviously, such a preparation method is cumbersome, time-consuming and labor-intensive, and during precise installation, the weld seam 30 will also affect the assembly, and the solar panel roof mounts and welding smoke during the welding process will cause varying degrees of harm to the human body.

Advantages of solar mounting brackets

The preparation is easy, the cost is low, and the harm to the human body is small. The welding-free photovoltaic bracket base, including the casing formed by bending the steel plate, does not require frequent replacement of fixing devices, which increases production efficiency. At the same time, the fixing effect is good and will not cause the photovoltaic modules to fall during welding. It will not cause damage to photovoltaic modules, and greatly improve the welding efficiency of photovoltaic modules.

Strength factory solar panel mounting brackets near me

solar panel bracket factory real workshop

structural steel beam clamps packing